Squaring up Blocks from Stitch and Slash Quilt Blocks

Stitch and Slash Blocks are fun, but it seems they rarely end up the exact size they should be and in order to have a “square” quilt, all the blocks should start out the same size. There must be a very compulsive streak in me because I just can’t sew blocks together that haven’t been “squared”. All these years of stitching has caught up with me and arthritis in my hands has slowed me down a bit.

Sherry has been helping me finish up some UFO’s and I pulled this set of blocks out for a Patience Corners quilt. They needed to be slashed and squared. They were made for comfort quilts for children using novelty fabrics. Here’s one of the blocks that has been slashed. It is an 8-1/2″ square of fabric cut with the AccuQuilt GO! 8-1/2″ square and 2-1/2″ strips sewn on the outside. After slashing and squaring, these blocks will be a cut size of 6″ square and will finish as 5-1/2″ square. 2016-10-18_img_6151-300-ppi

To square up these blocks I am using the 10″ square with the AccuQuilt GO! Big Cutter, but you can also use the 8-1/2″ square with the AccuQuilt GO! Cutter.

The first step is to mark the die. I use Painter’s Tape for this because it removes easily. Once upon a time, I marked my dies with Sharpie permanent markers, but soon my dies had many, many marks on them. To mark for this cut, I placed a ruler on the die and carefully placed a strip beside each edge. In the photo, you will see that there is a slight shadow on the edge of the ruler from the lamp lighting, but in reality, the tape placement is very accurate.

2016-10-18_img_6148-300-ppi

The next step is to place the fabric on the die. After getting this process going, it was easy to place two or three squares on each corner as the inner seam allowances fell on the foam and not on the die blades and the outer seam allowances could be alternated so there was no more than four thicknesses going through the cutter. Here’s the first square placement.

2016-10-18_img_6150-300-ppi

And here’s the second square placement. (Don’t you love the two tone foam so you can see exactly where this will cut?) As I worked, I found that it was easy just to line up the edges of the blocks with the tape on the side and not necessary to flip back the center corner to place the second square.

2016-10-18_img_6149-300-ppi

And this is what it looks like after going through the cutter. You can see the edges that have been trimmed and the perfectly squared blocks. In this example, I cut two blocks at a time.

2016-10-18_img_6152-300ppi

Can’t wait to show you the finished quilt.

And here’s one to show you that Sherry pieced, I quilted, and she is binding. It’s a comfort quilt for the Cancer Center.

2016-10-18-big-block-pieced-by-sg

One Reply to “Squaring up Blocks from Stitch and Slash Quilt Blocks”

Comments are closed.